The only table sawfence with AutomaticPositioning ControlTMSafety . . . . . . . . . . . . . . . . . . . 2Fasteners and Hardware Lists . . . . 2Rail
Calibration – Left side of saw bladeMoving your TS III to the left side of the blade can be quiteuseful, especially on table saws which have a blade t
If you wish to add a 3⁄4" thick table board between the righthand extension wing of your table saw and the TS III basemount assembly, begin by ma
AUXILIARY FENCE MOUNTINGFor some cutting operations, you may wish to add awooden auxiliary fence to the front face of your TS IIIfence. A T-slot is p
6 each 3⁄8– 16 x 11⁄2"hex bolt6 each 3⁄8"flat washer6 each 3⁄8"lock washer6 each 3/8 – 16hex nut2 each 3⁄8– 24 x 1"hex bolt(Delta U
6 each3⁄8– 16 x 3⁄4"hex bolt6 each1⁄4 – 20 square nut10 each3⁄8– 16rectangular nut8 each#10 – 32 x 7⁄16"phillips flat head screw8 each#10 – 3
INCRA Woodworking Tools & Precision Rules 4Unplug your table saw and remove the existing fence,including the front and rear support rails, mountin
The rail positions described above will provide supportfor the base of the TS III for work on either the left orright side of the blade. Left hand ra
Attach the INCRA Jig Ultra to basesupport panel and loosely attachremaining base clampOpen the Ultra Mounting Hardware Pack. Place #10 washerson each
Set final base assemblypositionLoosen the (4) base clamping knobs and slidethe base assembly to locate the near side of thebase support panel at 36&quo
Important: If you have not already done so, read theoperations section of your INCRA Jig Ultra owner’s manual(pages 6 and 7) to familiarize yourself w
FINAL CALIBRATIONImportant: As with any table saw fence,accurate calibration and alignment require thatthe saw blade be aligned parallel to the miters
Comments to this Manuals