Safety Instructions 2System Description 3Preparing your Shopsmith 4Installing the Ultra Base 6Fence Assembly 7Final Calibration 9Operation 10Ad
10 INCRA Woodworking Tools & Precision RulesWhen moving the rip fence in the area between the worktable and the Ultra base it is important to pro
INCRA TS-III ULTRA Shopsmith Owner’s Manual 11Figure 24Figure 25floating table along the extension tubes, or by shifting the position of the base supp
12 INCRA Woodworking Tools & Precision Rules4 "Lock" the carriage clampLift the micro adjust lever, and then pull the carriage clamp u
INCRA TS-III ULTRA Shopsmith Owner’s Manual 13The Ultra base and carriage clamp were designed to make it easy for the operator to adjust the clamping
14 INCRA Woodworking Tools & Precision RulesCarefully slide the carriage back into the Ultra base, taking care not to change the position of the
INCRA TS-III ULTRA Shopsmith Owner’s Manual 15well is to loosen the fasteners that secure the rip fence to the carriage then slide the carriage to wi
16 INCRA Woodworking Tools & Precision RulesThis page is intentionally blank.
2 INCRA Woodworking Tools & Precision RulesSAFETY INSTRUCTIONSImportant safety instructions for using the INCRA TS-III Ultra Before using the I
INCRA TS-III ULTRA Shopsmith Owner’s Manual 3SYSTEM DESCRIPTIONPositioning ControlThe INCRA TS-III Ultra obtains its great accuracy and repeatability
4 INCRA Woodworking Tools & Precision RulesPREPARING YOUR SHOPSMITH WORKSTATIONTo enjoy the full working range of the INCRA TSIII Ultra , you&apo
INCRA TS-III ULTRA Shopsmith Owner’s Manual 5Mark drill centers on the right edge of the remaining floating table as shown in Fig. 5 then use the (2)
6 INCRA Woodworking Tools & Precision RulesFigure 9INSTALLING THE ULTRA BASEFigure 10Figure 11Figure 12the endcap to one end of the base support
INCRA TS-III ULTRA Shopsmith Owner’s Manual 7Slide the carriage into the Ultra's base and position the fence mounting bracket above the right ed
8 INCRA Woodworking Tools & Precision RulesUHMW from the left side of one glide and the right side of the other. See Fig. 18. Using 1/4-20 x 1-
INCRA TS-III ULTRA Shopsmith Owner’s Manual 9Place the Ultra base in the micro adjust mode as described on page ____ and micro adjust the rip fence f
Comments to this Manuals